N9 Digital Hub User Guide


Turning the system on

Use the touch panel in the middle of the room between the two 98" displays, press anywhere to turn the system on.


Note: The touch panel on the right controls the room lighting. 


Touch panel location

Touch panel display after activation


Room mode

Select your required mode to begin:

  • Teaching Mode will turn every display screen on and show the PC on start up to all displays.
  • Event Mode will turn on the two 98” display screens and show the PC on start up to each display.


Return will go back to the previous page.


Select Teaching or Event Mode to begin

Bringing Your Own Device (BYOD)

To connect your device to this display use the one of the following key combinations:

  • Ctrl+K (Laptop)
  • AirPlay (MAC)


Select “BYOD-N9-Digital-Hub” from the Device List and enter the pin shown on any display screen. 




vSolutions screen sharing

Download the vSolution app to screen share, this can be accessed from:

  • Company Portal (Laptop)
  • RGU Apps (MAC)


Select “BYOD-N9-Digital-Hub” from the Device List and enter pin shown on any display screens.




Camera Select

This screen allows users to decide which camera to control.

  • Audience camera is facing audience above podium
  • Presenter camera is facing presenter in centre of room


The Close button will return to the main page. 




Camera Control

Here users can Pan/tilt, zoom and use pre-determined camera pre-sets.


Camera tracking follows either the audience or the presenter depending on which camera is selected. 


The Return button will return to the main page. 

Camera controls should be adjusted prior to beginning

Microphone Control

Here users can control the Microphone volume and Mute the mics.


It is recommended that users check the settings for their chosen device. 


Return microphones to their charging docks after use. 


The Return button will return to the main page. 

Use the sliders to adjust volume controls for individual devices


Help Screen

Use the Help screen if you experience any technical difficulties.


The Close button will return to the main page.

Contact the IT-AV Team for Support

Exiting the session

Power down button will shut down the system after use.


Power down the system after use